Transport And Start Up - Jet JTSS-1600 Operating Instructions Manual

U...... Riving Knife
V...... Main Blade
W......Scoring Blade
1...... Scoring Blade Alignment Screw
2...... Scoring Blade Lock Screw
3...... Scoring Blade Elevation Screw

5. Transport and start up

5.1 Transport and installation
The machine will be delivered on a crate.
Attention:
Do not remove the motor transport lock before the
machine has been set in place.
Do not operate the handwheels.
Use a forklift or lifting straps to lift the machine off the pallet
(Fig 3).
Warning:
The machine weight is heavy.
Assure the sufficient load capacity and proper condition
of your lifting devices.
Never step underneath suspended loads.
For transport to the desired location use a forklift or hand
trolley. Make sure the machine does not tip or fall off during
transport.
The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
Fig 2
Fig 3
To avoid machine tiping and for static stability, the table
support legs must always be installed and adjusted to the
floor.
The machine must be levelled in both directions to assure
good sliding motion of the sliding table.
If possible, the machine must be placed on rubber plates
which act as shock absorbers and reduce the noise level.
There must be suffient space to operate the machine
For packing reasons the machine is not completely
assembled.
5.2 Assembly
If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Some machine components are heavy. Get help from a
second person.
Mounting Rear Extension Table
Attach rear extension table to the machine table and put
surfaces in level with help of screws (U, Fig 5.
Fig 4
Fig 5