Transport And Start Up - Jet JWBS-14 Operating Instructions Manual

The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
Although there is a correlation
between emission and imission levels,
these do not constitute a basis for
determining the necessity of additional
safety measures. Workplace
conditions which could influence the
noise imission level include the
duration of resonance, spatial
particulars, other noise sources etc.
For example, the number of machines
and other work being performed. The
permissible workplace levels can vary
from country to country.
This information is intended to allow
the user to make a better estimation
of the hazards and risks involved.
4.3 Dust emission
The band saw JWBS-14 has been dust
emission inspected.
At an air velocity of 20 m/s on the dust
port dia 100mm:
Vacuum pressure
Volume flow
The machine meets the present
workplace dust emission limit of
2 mg/m³.
4.4 Content of delivery
Machine table
Fence
Fence support rails
Parallel cutting device
Mitre gauge
Assembly bag
Saw blade 10 mm
Operating manual
Spare parts list

5. Transport and start up

5.1 Transport and installation
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground.
The machine can be bolted down if
required.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Attach the machinestand with 16
screws, washers and nuts.
(Fig 1).
1250 Pa
565 m³/h
Mount the machine table to the
trunions and attach the lock knobs (A,
Fig 2).
Set the table to be square to the
sawblade and reference the table stop
(B, Fig 2) and the tilting scale (D, Fig
2).
Fig 1
Fig 2
5
Attach the support rails (G, Fig 3) to
the machine table with 4 hex cap
screws, 4 spring washers and 4
washers and align them parallel to the
table surface.
Fig 3
Attach the guide rail (H, Fig 3) with 5
hex cap screws, 5 spring washers and
5washers.
Place the fence assembly (B, Fig 4)
on the guide rail and align the fence
profile (A, Fig 4) to be parallel to the
mitre groove in the table.
Fig 4
Move the fence assembly flush to the
sawblade and set the pointer (C, Fig
4) to zero.
Fig 5
Check the clearance between the table
and the fence. The gap should be
appr. 1mm. Use the support rails and
the rear glide piece (E, Fig 5) to
adjust.