Table of Contents
Advertisement
Refer to Figures 3 and 4.
1 Band saw – A
1 Table insert – B
1 Table – C
1 Fence – D
1 Guide rail – E
1 Handle – F
2 Hex wrenches, 3mm,6mm – G
1 Wrench – H
1 Miter gauge – J
4 Stand legs – K
4 Rubber foot – L
2 Short support plate – M
2 Long cross brace – N
2 Long support plate – O
2 Short cross brace – P
1 Push Stick---R
1 Owner's Manual (not shown)
1 Part List (not shown)
1 Hardware package
Hardware package (JWBS10-HP), includes:
3 Hex cap screw, M8x55 – HP1
4 Hex washer head screw, M6x12 – HP2
32 Carriage bolt, M6x12 – HP3
4 Wing screw – HP4
4 Flat washer blk oxide M8 – HP5
6 Flat washer M8 – HP6
3 Lock washer M8 – HP7
3 Hex nut, M8 – HP8
32 Hex flange nut, M6 – HP9
5. Transport and start up
5.1 Transport and installation
For transport use a forklift or hand trolley. Make sure the
machine does not tip or fall off during transport.
The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
Fig. 4
Stability of bandsaw.
Before using the bandsaw, ensure the machines upright
stability is satisfactory.
The bandsaw has three Ø8mm holes (A, Fig 5 Fig.6 Fig.7)
in it's base to allow it to be bolted to a workbench or to the
supplied open stand
For packing reasons the machine is not completely
assembled.
Fig. 5
Fig.6
Fig. 7
Advertisement
Table of Contents
