Assembly - Jet JTSS-1600 Operating Instructions Manual

4.2 Noise emission
Determined according to EN 1870-18
(Inspection tolerance 4 dB)
Workpiece plywood 16mm:
Acoustic power level (according to EN ISO 3746):
Idling LwA
Operating LwA
Acoustic pressure level (according to EN ISO 11202):
Idling LpA
Operating LpA
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
Although there is a correlation between emission and
exposure levels, this cannot be used reliably to determine
whether or not further precautions are required.
Factors that influence the actual level of exposure of the
workforce include the characteristics of the work room, other
sources of noise, the number of machines or other adjacent
processes.
The permissible exposure level can vary from country to
country.
This information is intended to allow the user to make a
better estimation of the hazards and risks involved.
4.3 Dust emission
The circular saw has been dust emission inspected.
At an air velocity of 20m/sec on the dust port dia 100mm:
Vacuum pressure
Volume flow
The TRK-value of 2 mg/m
4.4 Content of delivery
Main crate
Main saw unit
Cast iron extension table
Steel plate extension table w/support leg
Rear extension table w/support
Swing arm assembly (inside main saw unit)
Cross cut table
Roller, cross cut
Blade guard
2-1/2" dust hose
Dust port
Mitre gauge
Hand wheels (2)
Hardwares
Tools
-13-15 mm open head wrench
- Arbor wrench
98,3 dB (A)
104 dB (A)
84,4 dB (A)
90,2 dB (A)
800Pa
565 m³/h
3
is not exceeded.
- Arbor pin
- 3, 4, 5, 6 mm "L" wrench
Push stick
(Some parts are inside the main saw unit)
Edge shoe
Rail crate
Rip fence
Rip fence rail
Rear support rail
Sliding table
Sliding table carrier
Support legs for sliding table (2)
Cross cut fence
Hold down w/fence
Flip stop
4.5 Description of machine
A......Crosscut Table
B.....Flip Stops
C.....Crosscut Fence
D.....Roller
E.....Sliding Table
F.....Blade Guard
G.....Rear extension table
H.....ON/OFF Switch
J......Blade Elevation Hand-wheel
K......Blade Tilt Hand-wheel
L......Mitre Gauge
M......Rip Fence
N......Fence Assembly Lock Down lever
O......E-stop button
P......Fence profile lock lever
Q......Rip Fence Rail
R......Support Leg
S......Blade Tilt Lock Knob
T...... Hold Down w/Mitre Gauge
Fig1