Jet JTSS-1600 Operating Instructions Manual page 10

Place a T-nut into the top slot of fence, thread the stud of
hold-down on fence.
If need, put the hold down arm onto the stud (E).
Reference to chapter 7.8
Mounting Mitre Fence
See chapter 7.9
Mounting Sawblade
See chapter 7.1
Mounting sawguard
The riving knife has slots for different blade sizes Fig 18
Min blade size Ø 250mm, max blade size Ø 315mm
Reference to chapter 7.3
5.3 Dust connection
Install the 2" dust hose onto the blade guard with 2" hose
clamp. Fig19
Put the 2" dust hose onto dust hose support, keep free
with the working table.
Another end of 2" dust hose clamps to the main dust port on
the bottom of rear panel.
Install 4" dust hose to main dust port with 4" hose clamp.
Fig18
Before initial operation, the machine must be connected to a
dust extractor.
The suction should switch on automatically when the saw is
switched on.
A hose, a Y-piece and a hose support are supplied with the
machine.
The flow rate on the suction port dia 100mm must be
20m/sec.
Flexible hoses must be of nonflammable quality, and must
be connected to the machine ground system.
5.4 Mains connection
Mains connection and any extension cords and plugs used
must comply with the information on the machine licence
plate.
The mains connection must have a 16A surge-proof fuse.
Only use connection cables marked H07RN-F, with wires
2
1,5mm or more.
Power cords and plugs must be free from defects.
Connections and repairs to the electrical equipment may
only be carried out by qualified electricians.
The machine is equipped with a 16Amp CCE Euro plug,
mounted at the back side of the frame.
Attention:
-Check first if the saw spindle runs freely and if all safety
devices are fitted before starting the machine.
- If the direction of rotation is not correct, the phase converter
inside the CCE Euro plug must be pushed in and turned
180°.
Fig 19