Machine Operation - Jet JTSS-1600 Operating Instructions Manual

(Clockwise direction of the main spindle is correct).
For safety reasons this must only be done without the
sawblade installed!
5.5 Starting operation
You can start the machine with the green On-button. The red
Off-button stops the machine.
The scoring sawblade is started and stopped simultaneously
with the main sawblade.
Note:
-When the lower sawblade cover is open, it is impossible to
start up the machine.
-In case of machine overload the motor overload cut-off will
react. After appr.10 min of cooling the machine can be
started again.

6. Machine operation

Correct working position:
In front of the machine standing out of the line of cutting
(danger zone) Fig 20.
Work piece handling:
Hands placed flat on the work piece outside the cutting area.
Feed the work piece towards the saw blade in the direction
of the saw line. Push the work piece steadily forward;
complete the cut as a single movement.
Support long and wide workpieces with helping roller stands.
The use of a power feeder is not considered.
Crosscut with crosscut fence
Fig 20
Trimming with back stop
Operating hints:
Work only with a sharp and flawless sawblade.
Take care that the selection of the saw blade depends on the
material to be cut.
Use a suitable wedge to prevent round timber from turning
under the pressure of the cut.
Use suitable table extensions and supporting aids for difficult
to handle workpieces.
Always hold and guide the workpieces safely during
machining.
The fence must securely be locked before machine use.
Do not perform any operation freehand.
Guide and push the workpiece against the fence.
Take care when slotting.
When ripping narrow workpieces (<120mm) use as push-
stick or push wood.
Push sticks and push woods shall be made from plastic,
wood or plywood.
Fig 21
Fig 22