Troubleshooting - Jet JTSS-1600 Operating Instructions Manual

Replace new V-belt, tension belt, close the left panel, and re-
mount inner chip house, blade, blade guard.
Reattach the rear machine access door.
Scoring unit belt tensioning:
The scoring unit belt is self tensioning by spring load (Fig 39).
Scoring unit belt changing:
Move the blade tilt to 0˚ (Blade 90˚ to table) on the control
panel and lower the blade as far as it will go.
Remove the 4 Allen screws on the top and bottom of right
panel, and remove the left panel.
Push the tension pulley against the spring load.
Remove the old belt and replace new belt.
Re-mount the right panel.
Motor Break:
The motor break works electro-mechanically (break motor).
If breaking time should exceed 10 seconds, the motor break
assembly needs to be replaced. Contact your Jet service
station immediately.
9. Trouble shooting
Motor doesn't start
*No electricity
-check mains and fuse.
*Defective switch, motor or cord
-consult an electrician.
*Overload has reacted
-Wait and start again.
*Lower sawblade cover still open
- Close cover correctly.
Machine vibrates excessively
*Stand on uneven floor
-adjust levelling screws for even support.
*dust on sawflanges
-clean saw arbor and flanges.
*defective sawblade
- replace sawblade immediately
*Bad V-belts
-replace V-belts
Cut is not accurately square
Fig 39
*Stops not adjusted correctly
-check with square and adjust stops.
Material binds blade when ripping
*Fence not aligned with sawblade
-check and adjust rip fence.
*Wrapped wood
-select another piece of wood.
Material kicked back from blade
*Fence not aligned with sawblade
-check and adjust rip fence.
*Raving knive not in place
-high danger, mount immediately with saw guard.
Cutting surfaces is bad
*Wrong sawblade used
*Blade mounted backwards
*Resin collection on sawblade
*Sawblade is dull
*Workpiece inhomogeneous
*Feed pressure too high
-do not force the workpiece.
Blade does not raise or tilt
*Sawdust in mechanisms
-clean-and regrease.
Sliding table does not move
*Sawdust in bearing guides
-wipe out any sawdust.
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled.
Please leave it at a specialized institution.
11. Available accessories
Refer to the JET-Pricelist
for various accessories.
12. Safe operation
See appendix A (on the last pages of
this operating manual)
A.1.: Ripping
A.2.: Ripping of narrow stock
A.3.: Crosscutting on ripfence
A.4.: Use of push wood handle