Powering On The Base Unit With Its Extension Cards - eWON FLB 3271 Installation Manual

4. Powering On the Base Unit with its Extension Cards

When the Base Unit is powered on, it takes approximately 25 seconds for the unit to go
through its self-test procedure. The slots in which the extension cards have been inserted
and their type are detected during this process.
If the boot process completes normally, you should observe the following LED status
Base Unit
•
Extension Card
•
- Note -
If the USR LED of the Base Unit flashes RED, it might be because the Extension Card was
improperly inserted (for example in a wrong slot).
Page 14 / 19
Powering On the Base Unit with its Extension Cards
USR flashing green slowly
None
eWON Flexy WiFi Extension Card FLB 3271 | IG 020
Chapter 4