Multiple Wifi Extension Cards - eWON FLB 3271 Installation Manual

Hooks to be pressed are off-centered – press while pulling upwards
This metal tag soldered on the PCB acts as mistake-proof security (mating stop in
housing)
Insert the Extension Card carefully and slide it down until the hooks are clicking. Make sure
the card is completely inserted. DO NOT insist if you feel some resistance when trying to
insert the card. It probably means you are trying to insert the card in a wrong slot. In such
case, check slot compatibility of the relevant Extension Card.
- Note -
If an extension card is inadvertently forced in a wrong slot, the Base Unit will detect it and will
NOT complete its BOOT process. Therefore, the unit will not be accessible through its LAN
interface. The slot error is returned by the USR LED. (red ON 1sec, OFF 0.5 sec).

3.6.4. Multiple Wifi Extension Cards

The eWON Flexy firmware currently supports up to one Wifi Extension Card of type FLB3271.
The boot process of the Base Unit includes an automated detection of the inserted
Extension Cards. This detection is done sequentially, slot per slot starting from the left to right.
Page 12 / 19 eWON Flexy WiFi Extension Card
Chapter 3
Hardware Description
FLB 3271 | IG 020