4. If installing a floppy drive, attach one end of the cable to its
connector on the CPV5300. To attach the cable, push up on each end
of the plastic connector. The connector releases so that the cable can
be inserted in the connector. Insert the cable into the connector and
push down on each end. Attach the other end of the cable in step 8.
5. Install the floppy drive in the drive carrier. Attach the floppy drive
to the carrier with two screws on each side. Refer to the figure
below.
6. If you are installing a hard drive, attach the cable to the drive and the
IDE connector on the CPV5300.
Installing the On-board Disk Drives
4
2170 9803
4-5