Prune Stations - Dab - Roberts Blutune 5 Manual

Prune stations - DAB

If you move to a different part of the country, some of the stations which were
listed may no longer be available. Also, from time to time, some DAB services may
stop broadcasting, or may change location or frequency. Stations which cannot
be found, or which have not been received for a very long time are shown in the
station list with a question mark.
The Prune stations function will delete the marked DAB stations from your station list.
1. When in DAB mode, press Menu.
2. Rotate Tuning until 'PRUNE' is displayed. Press Tuning.
3. 'PRUNE?' will be displayed. Press Tuning to cause the invalid station names
to be removed from the station list.
4. If you do not wish to prune stations press Menu to exit.
Note: If you have moved your radio to a different part of the country you should
stations' on page 8).
Operating your radio - FM
1. Carefully extend the telescopic aerial fully. Press On/Standby to switch
on the radio.
2. Press Mode until the 'FM' mode is selected.
3. Rotate Tuning clockwise and then apply a long press on Tuning. Your radio
will scan in an upwards direction (low frequency to high frequency) and stop
the display will update. The display will show the frequency of the signal found.
If the signal is strong enough and there is RDS data present then the radio
will display the station name.
rotate Tuning anti-clockwise and then apply a long press on Tuning.
'SCAN'. Press Tuning.
6. When the waveband end is reached your radio will recommence tuning from
the opposite waveband end. Adjust the Volume. To switch off your radio press
On/Standby.
Menu. The display will show
DAB
DAB
FM
FM
10