Installing Sf/Cpm Modules - Alcatel-Lucent 7450 ESS-7 Installation Manual

Installing SF/CPM Modules

I SF/CPM M
NSTALLING
W
ARNINGS AND
Warning:
• Electrostatic discharge (ESD) damage can occur if IOMs, SF/CPMs, or MDAs are mishandled.
Always wear an ESD-preventive wrist or ankle strap and always connect an ESD strap to the
grounding plug on the front of the chassis.
• Always place chassis components on an anti-static surface.
• Do not power up the 7450 ESS-7 chassis until all components are installed and verified.
• Blank panels and faceplates are required in all empty card and component slots to prevent excess
dust accumulation and to help control airflow and electromagnetic interference. Faceplate blanks
do not have board components or connector pins.
Notes:
General:
• SF/CPM modules do not require preconfiguration. Factory default values allow the system to
boot successfully.
• All 7450 ESS-7 systems require at least one SF/CPM.
• Install the SF/CPM before installing IOMs.
• Do not force an IOM into a SF/CPM slot.
• Do not force a SF/CPM into an IOM slot.
7450 ESS-7:
• The 7450 ESS-7 card slots are horizontally oriented.
• Each system requires at least one SF/CPM to operate. The SF/CPM must be installed in bottom
slot labeled A or B.
• IOMs are designed to fit in slots numbered from top to bottom, 1 through 5.
Page 82
ODULES
N
OTES
7450 ESS-7