Optical - Marantz ND8006 Owner's Manual

Contents Connections
NOTE
0 Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
0 When this unit is functioning as a D/A converter, sound is not output from the
computer's speakers.
0 If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
0 When an error occurs on the computer, disconnect the USB cable and restart the
computer.
0 The sampling frequency of the music playback software and sampling frequency
displayed on this unit may differ.
0 Use a cable that is 10 ft (3 m) or less to connect to the computer.
Front panel Rear panel
Playback Settings
Connect and playback from a digital
device (Coaxial/Optical 1/Optical 2)
1
o Specifications of supported audio formats
See "D/A converter" (v p. 134).
NOTE
0 Do not input non-PCM signals, such as Dolby Digital and DTS. This causes noise
and could damage the speakers.
71
Remote control
unit
Tips
Press COAXIAL, OPTICAL 1 or OPTICAL 2 to switch the
input source to "Coaxial", "Optical 1" or "Optical 2".
If the sampling frequency cannot be detected, "Signal Unlock" will
0
be displayed.
"Unsupported" is displayed when audio signals that are not
0
supported by this unit are input.
Index
Appendix