Table of Contents
Advertisement
n Audio signals that can be played back
See "D/A converter" (v p. 36).
NOTE
Perform operations such as playback and pause on the
0
computer. At this time, you cannot perform operations with
buttons on this unit or the remote control.
When this unit is functioning as a D/A converter, sound is
0
not output from the computer's speakers.
If the computer is disconnected from this unit while the
0
computer music playback software is running, the playback
software may freeze. Always exit the playback software
before disconnecting the computer.
When an error occurs on the computer, disconnect the
0
USB cable and restart the computer.
The sampling frequency/bit length of the music playback
0
software and sampling frequency/bit length displayed on
this unit may differ.
Use a cable that is 3 m or less to connect to the computer.
0
Connect and playback from a digital
device (Coaxial/Optical)
1
Press DISC/INPUT to switch the playback
media mode to "Coaxial" or "Optical".
The digital audio signal that is being input is shown as
follows in the display.
When a linear PCM signal is input
0
GExampleH PCM176.4k/24
Files are displayed in order of sampling frequency
0
and bit length.
The displayed bit length is the bit count at the
0
time the audio signal is input from the external
device to the D/A converter of this unit.
If the sampling frequency cannot be detected,
0
"Unlock" will be displayed.
"Unsupported" is displayed when audio signals that
0
are not supported by this unit are input.
n Specifications of supported audio
formats
See "D/A converter" (v p. 36).
NOTE
Do not input non-PCM signals, such as Dolby Digital and
0
DTS. This causes noise and could damage the speakers.
Specifying the desired sound
quality
Switching the filter characteristics
This unit is equipped with a sound quality adjusting function
which allows users to enjoy the desired playback sound
quality. The unit supports PCM signal.
The 2 filter characteristics types are explained below.
Filter Type
Features
Filter 1
Very short but symmetrical impuls response.
Very precise soundstage and smooth tonal
balance.
Filter 2
Very short pre-ringing - long post-ringing.
Neutral tonal balance - slightly brighter than
"Filter1".
1
Press FILTER
The setting cycles through the 2 modes (Filter 1 / Filter
2) as shown below each time the button is pressed.
NOTE
The filter characteristics have a last memory function.
0
These settings remain in memory even if a disc change
occurs, or if the power is turned off.
The filter function does not work during playback of Super
0
Audio CDs or DSD audio sources.
ENGLISH
22
Advertisement
Table of Contents
