Wildgame I6 User Manual page 6

Power On
1.
To turn the unit ON, press and
release the power button.
Ready
Time/Date
Location
Trigger
POWER
Flextime
PIR Mode
PIR Active
Delay
2.
Check the battery level icon to
ensure the
installed contain
charge level. If so, you are ok to
proceed with camera use.
Ready
Time/Date
Location
Trigger
PIR Mode
Flextime
P1
PIR Mode Still
PIR Active 24Hr
Delay 30sec
NOTE: LCD cycle through camera
information. PIR picture number >
Flextime number
pictures > Time
page 5
PIR Mode Flextime Both
P1 P2 Interval
Still Video
24Hr Day Night
30sec 1min 2min 5min
batteries just
the proper
Flextime Both
P2 Interval
Video
Day Night
1min 2min 5min
> Remaining
Test Mode
1.
LCD Ready Mode: The camera
will automatically enter Ready
Mode if a button is not pressed
for greater than 30 seconds. The
status lights will illuminate for a
total of 2 minutes.
2.
PIR LED Status Light: During the
first 2 minutes of Ready Mode,
the red light will illuminate when
a PIR event is triggered. The red
light will blink for 2-3 seconds
when photo is taken during this
first 2 minutes. After 2 minutes
all indicator lights will turn off
until a button is pressed.
Ready
Time/Date
Location
Trigger
Flextime
POWER
PIR Mode
PIR Active
Delay
PIR Mode Flextime Both
P1 P2 Interval
Still Video
24Hr Day Night
30sec 1min 2min 5min