b. Press the tabs
1
from the front of the computer. Then, release the tabs and continue to slide the optical drive into the
bay until it snaps into position.
Figure 14. Installing the optical drive
c. Connect the signal cable and the power cable to the new optical drive.
Note: Reconnect any cables removed from other supported devices.
Figure 15. Connecting cables to the optical drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 220.
Storage drive in the front-access storage enclosure
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
toward each other as shown, and slide the new optical drive halfway into the bay
.
Chapter 9
Hardware removal and installation
107