Removing The Battery - Samsung N150 User Manual

1. Insert the contact end on the bottom of the battery into the slots on the
bottom of the phone.
2. Slide the battery up until you hear it click into place.

Removing the battery

To remove the battery from your phone:
1. Turn the phone off (by pressing and holding [END] until the closing
animation sequence begins.)
2. Push the catch button up on the top of the battery on the back side of the
phone. (see illustration). The battery will easily slide out from the phone.
Charging the battery
Note: A standard battery is provided with your phone. The battery must be fully
charged before using your phone for the first time. The phone can be used
while the battery is charging.
Your phone is powered by a rechargeable Li-ion battery. Only use
Samsung approved chargers and batteries. These chargers are
designed to maximize battery life. Using other chargers voids your
warranty and may cause damage.
When the phone has finished charging it can be disconnected from the charger.
Low battery indicator
You can tell whether or not your battery needs to be recharged by
checking the indicator (it's located in the upper-right corner of
the display). The presence of all three bars indicates a full charge, two
bars indicates a medium charge, and one bar indicates a minimum
charge. No bars (the battery icon is empty) indicates the battery no
longer has any charge and must be recharged.
The empty battery icon
Two to three minutes before the battery charge level gets too low to
operate the phone, the battery sensor will let you know by blinking an
empty battery icon (
operate the phone without charging the battery, the phone will turn off
automatically. If this happens, your wireless call will be ended. But if
you plug into a charging device, you can continue your call. Be sure to
monitor the battery strength icon and make sure your battery is
sufficiently charged.
Charging with the travel adapter
The travel adapter allows you to charge your phone's battery from any
standard 110 V AC wall outlet. Also, using the travel adapter allows you to
make a phone call while the battery is charging. The travel adapter will
fully charge an " empty" standard battery in about three hours, and an
" empty" extended battery in about four hours.
Follow these steps:
1. With the battery connected to the phone, connect the travel adapter to
the accessory connector on the bottom of the phone.
2. Connect the charger to a standard 110 V AC wall outlet. The battery begins charging.
3. The LED on the travel adapter indicates the status of the battery charge.
.
Red indicates that the battery is charging.
.
Green indicates that the battery is fully charged.
.
Flashing Red indicates that the battery is operating at a temperature that is
too high or too low, or that the charger is not plugged in correctly.
SCH-N150 User Guide Draft Rev 1.2
), and sounding a tone. If you continue to
3/16/01 23