Lucent Technologies MDW 9040 Installation, Troubleshooting, And Use page 23

2
Installing and Registering the MDW 9040 Pocket Phone Installation Procedures for the DRM
The following is a diagram showing three DRM units operating in a single-zone configuration providing six
handsets with the appropriate switch interface.
12
Issue 1, May 2000
Figure 4. Three DRMs Connected and In Sync
To install multiple DRMs for single-zone operation:
1 Remove each DRM from its shipping box and place it in the location specified by
the customer or use the wall-mounting template (provided on the last page of this
book). To wall-mount the DRM, see the instructions for wall-mounting on
page 10.
For the first handset to be connected to the DRM, connect a 14-foot D8W line
2
cable to Line 1 on the DRM and then connect the other end of the cable to a
switch port at the main system. If a second handset is to be connected to the
DRM, connect another line cable to Line 2 on the DRM and then connect the
other end of that cable to another switch port.
Note:
If the DRM cannot be connected to an associated switch, the DRM can be
temporarily connected to an auxiliary power supply that can provide
electrical power.
Repeat Steps 1 and 2 for each DRM and handset combination in this
3
configuration.
To daisy chain two or more DRMs, plug a 20-inch synchronization cord from the
4
Sync jack on one DRM to the Sync jack on the other DRM.
IMPORTANT NOTE: When two or more DRMs are synchronized,
only one DRM should have the CONTROL LED lit.
5 Verify that the DRM has power and that the status LED information is correct.
See DRM Light Indications.
6 Proceed to "Setting Up and Registering the Handset" on
MDW 9040 Wireless Pocket Phone Installation, Troubleshooting, and Use, 503-801-190
page 13.