Hitachi HVM Navigator V03-06 User Manual page 187

The same values as those set on the Storage Navigator Modular 2 CLI and
each storage device should be set for each of the above parameters in this
window. Otherwise, it's possible that you cannot register migration WWPNs
through HVM Navigator.
The values which you should set for the parameters for Administration mode
are shown in Table 3-4: the values vary depending on the setting on the
Storage Navigator Modular 2 CLI. Also, the values which you should set for the
parameters for Password Protection and Account Authentication are shown in
Table 3-5: the values vary depending on the setting on each storage device as
well.
In addition, you can check Save password setting check box. When you check
the check box, the above parameters are saved after clicking OK button. So,
use the check box as needed.
Table 3-4 Setting for Administration mode
Setting for Administration Mode
on Storage Navigator Modular 2 CLI
Enabled
Disabled
Table 3-5 Setting for Password Protection and Account Authentication
Setting on Storage device
Password Protection
Account Authentication
Not set
HVM Navigator User's Guide - Migration
Value which you should set in Storage Password Setting
Administration Mode check box
Checked
Unchecked
Value which you should set in Storage Password Setting window
Security Type column
Password Protection
Account Authentication
Not used
Migration procedures
window
Password text box
Input the password
Not available
User ID
Input the User ID Input the password
Input the User ID Input the password
Not available Not available
Password
3-91