Starting The Engine - Briggs & Stratton 100000 Operator's Manual

Operation
WARNING
This snowthrower is only as safe as the operator. If it is
misused, or not properly maintained, it can be dangerous.
Remember you are responsible for your safety and those
around you.
• When leaving the operating position always disengage
the auger, turn off the engine, and remove the key. Never
leave a running machine unattended.
• Never operate the snowthrower without proper guards,
and other safety protective devices in place and working.
• Exercise extreme caution when operating on or crossing
gravel drives, walks, or roads. Stay alert for hidden
hazards or traffic.
• Never operate the snowthrower without good visibility or
light. Always be sure of your footing, and keep a firm hold
on the handles. Walk; never run.
• Exercise caution to avoid slipping or falling, especially
when operating the snowthrower in reverse.
• Exercise extreme caution when operating on slopes.
• After striking a foreign object, stop the engine (motor),
remove the wire from the spark plug, disconnect the cord
on electric motors, thoroughly inspect the snowthrower
for any damage, and repair the damage before restarting
and operating the snowthrower.
• Do not operate the equipment without wearing adequate
winter garments. Avoid loose fitting clothing that can get
caught in moving parts. Wear footwear that will improve
footing on slippery surfaces.
• Never touch a hot muffler or engine. Allow muffler/engine
cylinder to cool before touching.
Operating Area
1. Familiarize yourself with the area in which you plan to
operate the snowthrower. Mark off all boundaries of
walkways and driveways.
2. Ensure the area to be cleared is free of debris or objects
that could be picked up by the auger and thrown from the
chute.
WARNING
This machine is capable of throwing objects that could injure
bystanders or cause damage to buildings.
3. Before starting the engine, move the snowthrower outdoors
and away from windows and doors.
6
WARNING
Engines give off carbon monoxide, an ordorless, colorless,
poison gas. Breathing carbon monoxide can cause nausea,
fainting, or death.
• Start and run engine outdoors.
• Do not run the engine in an enclosed area, even if doors
or windows are open.
4. Ensure the operating area is clear of bystanders, especially
children.
WARNING
This snowthrower is capable of amputating hands and feet,
and throwing objects. Read and observe all the safety
instructions in this manual. Failure to do so could result in
death or serious injury.
• Keep children out of the area during operation.
• Children are often attracted to the equipment. Be mindful
of all persons present.
• Be alert and turn the unit off if bystanders enter the area.
• Use extra care when approaching blind corners, shrubs,
tress, or other objects that may obscure vision.

Starting the Engine

Checking Oil
NOTICE
The engine was shipped from the factory without oil. Before
you start the engine, ensure that you add oil according to the
instructions in this manual. If you start the engine without oil,
it will be damaged beyond repair and will not be covered under
the warranty.
Use Briggs & Stratton Synthetic 5W-30 Warranty Certified oil
for best performance. Other high-quality detergent oils are
acceptable if classified for service SG, SH, SJ or higher. Do
not use any additives.
1. Place the unit on a level surface.
2. Clean the oil fill area of any moisture or debris.
3. Remove the oil dipstick (A, Figure 3) and wipe it with a clean
cloth.
4. Insert and tighten the dipstick, then remove it again to check
the oil level. It should be at the top of the full indicator (C)
5. To add oil, pour slowly into the engine oil fill (B). Do not
overfill.
6. Wait one minute before checking the oil level.
7. When the oil level is at the top of the full indicator (C), install
and tighten the dipstick.