Tektronix WVR5200 Declassification And Security Instructions page 10

Clear and Sanitize Procedures
Data Export Devices
Table 3: Data export devices
Type and
minimum
size Function
Ethernet Communications
Data storage
USB
1 During normal instrument operation.
Disable Ethernet Access
Procedure
Disable SNMP Access
Procedure
Enable Ethernet and SNMP
Access Procedure
4
The following table lists the data export devices in the standard instrument and
listed options. Detailed procedures to disable these devices, if any, are shown
following the table.
User
modifiable 1 Data input method
Yes Standard Ethernet
protocol
Yes
Standard USB protocol
1. Press the CONFIG button. Then select Network Settings.
2. Navigate to the Web Enable and set it to Off.
3. Press the CONFIG button to exit the configuration menu.
1. Press the CONFIG button. Then select Network Settings.
2. Navigate to the Web Enable and set it to Off.
3. In the SNMP Setup dialog screen, select Disabled for the Remote SNMP
Mode.
4. Press the CONFIG button to exit the configuration menu.
To enable Ethernet and SNMP access, use the same procedures you would use to
disable these devices, but select On to enable each device.
Location To disable
Rear of instrument See Disable Ethernet Access Procedure
and Disable SNMP Access Procedure
None
Front of instrument
WVR5200 Declassification and Security