Bmc Network Configuration - Supermicro FatTwin F619P2-RT User Manual

FatTwin F619P2-RT/RTN/RC0/RC1 User's Manual
Erasing Settings
Erase SEL
Select Yes, On next reset to erase all system event logs upon next system reboot. Select
Yes, On every reset to erase all system event logs upon each system reboot. Select No to
keep all system event logs after each system reboot. The options are No, Yes, On next reset,
and Yes, On every reset.
When SEL is Full
This feature allows the user to determine what the BIOS should do when the system event
log is full. Select Erase Immediately to erase all events in the log when the system event log
is full. The options are Do Nothing and Erase Immediately.
Custom EFI Logging Options
Log EFI Status Codes
Select EFI (Extensible Firmware Interface) Status Codes to log EFI status codes. Select Error
Codes to log EFI error codes. Select Progress Code to log the EFI progress code. Select
both to log both EFI error codes and progress codes. The options are Disabled, Both, Error
code and Progress code.
Note: After making changes on a setting, be sure to reboot the system for the changes
to take effect.
BMC Network Configuration

BMC Network Configuration

Configure IPV4 Support
This section displays configuration features for IPV4 support.
IPMI LAN Selection
This item displays the IPMI LAN setting. The default setting is Failover.
IPMI Network Link Status
This item displays the IPMI Network Link status. The default setting is Shared LAN.
Update IPMI LAN Configuration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If the item above is set to Yes, the following item will become available for configuration:
112