Table of Contents
Advertisement
A. CHOOSING A GOOD LOCATION
Place the unit in a location with adequate air circulation to prevent internal heat
build up.
Use the dimensions specified in Section 10 as a guideline for the minimum
clearances to the unit.
NOTE: Allow for adequate clearance above the unit to accommodate the height of the unit with its
cover open.
Do not place the unit in a location where the ventilation holes located on the
left of the unit could become blocked.
Do not install unit near heat sources such as radiators or air ducts, or in a place
subject to direct sun-light, excessive dust, mechanical vibration or shock.
B. ABOUT MOISTURE CONDENSATION
If the unit is brought directly from a cold to a warm location, or is placed in a very
damp room, moisture may condense inside the unit. Should this occur, print
quality may not be optimum. Leave the unit turned off in a warm, dry room for
several hours before using. This will allow the moisture to evaporate.
Getting Started
Digital Label Press 3 User's Manual
3
Section 3: Getting Started 9
Advertisement
Table of Contents
