Table of Contents
Advertisement
5. Click Finish. Once the driver for your USB cable is installed, connect the other
end of the cable to the parallel interface port located on behind the press.
The Control Panel LCD must display, "PRINTER READY CUTTER READY" in
order to receive data.
IMPORTANT! In order to begin printing with this press, you must first install its custom printer
driver software along with the PressPrint software for Windows. For instructions
on installing and using this software, please refer to Section 7 of this manual.
Digital Label Press 3 User's Manual
Section 5: Connecting the Press 37
Advertisement
Table of Contents
