Table of Contents
Advertisement
Digital Label Press 3 User's Manual
Cancel/-
The Cancel button cancels cutting and ejects the page. As a fail-safe, the Retry
button must first be pressed to pause cutting. When the Printer Hood is opened,
pressing Cancel will force the paper to reverse through the paper path. This is
useful in unloading the paper roll. The Cancel key also functions as "-" to step back
through previously displayed options when using the Menu feature of your press
as described below. When the Printer Hood is closed, press Cancel and Retry
simultaneously to reset the press's processors and clear its memory buffer.
Menu/+
The Menu/+ will open the menu options. The menus will allow you to load paper
and select some cutter settings. Once in the menu, this button performs the "+"
feature to advance through available options while Cancel/- allows you to display
the previous selection of the menu item. The following table describes the menu
items available on your press:
Menu Item
PAPER LOAD SEQ
ENTER WHEN READY
PAGE COUNT: 0000
ENTER TO ZERO
TEST PRINT
ENTER WHEN READY
PAGE LOAD TEST
ENTER WHEN READY
NOTE: The Menu will automatically close if no button is pressed for a period of 10 seconds.
Retry/ Enter
The Retry button is used to continue press operation after an error has occurred.
For example, if your press runs out of ribbon, the machine will stop printing and
an OUT OF RIBBON error will be displayed on the LCD. Once a new ribbon has
been installed, you can press the Retry button to continue the job. The Enter
feature is used to select a choice in Menu mode as described above. When the
Printer Hood is open, pressing Retry will force-feed the media through the paper
path. With the Printer Hood closed, pressing Retry and Cancel simultaneously will
reset the press's processors and clear its memory buffer.
12 Section 3: Getting Started
Table 3.2. Menu Items in the Control Panel Display
Description
This will initialize a paper load sequence that cuts
the leading edge of the sheet and positions the
paper for printing. This is used when loading a new
roll and is describe in detail in section 4-G.
This will reset the PAGE COUNT feature (described
on page 13) to 0.
This will initiate a printer self test described in
detail in section 5-A
This tests the paper path of the press and is
described further in section 5-A
Advertisement
Table of Contents
