Log Set And Coal Installation - Lopi Heritage-2000 Owner's Manual

Installation

Log Set and Coal Installation

Step 1 Before installing the log set, make sure the burner is seated correctly.
Remove the burner and check the items below.
Replace the
a
burner, making
sure the burner
tubes line up with
the mixing tubes.
Make sure the burner is
b
fully seated. When in
place, the pilot flame
must align directly
above the burner holes.
Step 2
Place the rear log on the two
a
platforms at the rear of the
firebox.
Place the two pins,
b
included in the hardware
pack, into the burner.
Travis Industries
(for qualified installers only)
NOTE:
Make sure the "O" rings seal the burner
tubes to the mixing tubes.
HINT:
If the burner does not insert easily, make sure the
screws holding the rear mixing tube in place are
slightly loose. This allows the mixing tube to move
slightly and align with the burner tube.
9 3 5 0 8 1 2 1
17
O-Ring
Burner Tube
Mixing Tube
These pins insert
into the holes in
the log.
2 3 1 0 0 0