Table of Contents
Advertisement
3e–527A3 Wireless Access Point – 8 Port
Manual Bridging
When the wireless bridge is in manual bridging mode, you can manu-
ally select a signal strength LED MAC and enable or disable spanning
tree protocol. You can also delete remote AP's MAC addresses.
MANUAL BRIDGING GENERAL SETTINGS OPTIONS
Bridging
Manual Bridging
Mode
Signal
Not Assigned
Strength LED
MAC
Spanning Tree
Enable/Disable
Protocol (STP)
84
Chapter 5: Wireless Bridge Configuration
manual bridging selected
Allows you to set the number of one of
the Remote APs which will be listed at
the bottom of the screen once the system
is operational This wireless bridge be-
comes the guiding port that is displayed
in the WLANNSS LED on the front of
the 3e–527A3 as a signal.
Enable STP is there is any possiblity that
a bridging loop could occur. If you are
certain that there is no possibility that
a bridging loop will occur, then disalbe
STP. The bridge will be more efficient
(faster) without it. If you are not sure,
the safest solution is to enable STP.
29000152-001 B
Advertisement
Table of Contents
