Table of Contents
Advertisement
3e–527A3 Wireless Access Point – 8 Port
Wireless Clients
The Monitoring/Report — Wireless Clients screen displays the MAC
Address of all wireless clients and their signal strength and transmit rate.
The screen shown here emulates the FIPS 140-2 setup and contains a col-
umn for EMCON response. The EMCON feature only works with 3e-010F
Crypto Client in FIPs mode.
If Transmit power is disabled, either by setting TX Pwr Mode to Off
on the management screen or by using the RF Manager (Chapter 7), the
Wireless Clients page will show the results from each associated client
in the EMCON Response column. If the client responds to the "disable"
command, a Yes is displayed. If the column contains a No, this can mean
either:
• the client didn't receive the command, or
• the client is no longer in the areas, or
• the client software doesn't support the RF management feature.
This status information remains active for 5 minutes after the clients
are disabled.
50
Chapter 3: Access Point Configuration
29000152-001 B
Advertisement
Table of Contents
