Table of Contents
Advertisement
3e–527A3 Wireless Access Point – 8 Port
To use the Configuration/RESET button push the button for two
seconds. After two seconds the WLAN2 and WLANSS LEDs are turned
off. These two LEDs can then be used as input indicators.
The procedure to enter the password is:
Example: 11111111
Push the Configuration/RESET button once (input is acknowl-
edged by the signal strength LED) and wait for one second. The WLAN2
LED blinks to acknowledge the first digit was accepted. Repeat eight
times.
To reset the unit:
1.
Push in and hold the Configuration/RESET button for five sec-
onds (input is acknowledged by the WLANSS LED turning on).
2. After five seconds, you can release the button to reset the unit
without factory default.
3. If you continue to hold the button, after 10 seconds the WLANSS
will turn off and the unit will be reset to the factory default.
The signal strength LED and WLAN2 LEDs will go back to normal if
there is no input in 10 seconds.
60
Chapter 3: Access Point Configuration
29000152-001 B
Advertisement
Table of Contents
