Table of Contents
Advertisement
3e–527A3 Wireless Access Point – 8 Port
Monitoring
In the upper right-hand corner of the Wireless Bridge — General
screen there is a button called Monitoring. f you click on this button,
a pop-up window will appear (WDS Information). If you select En-
able refresh, you can set the bridge refresh interval from 5 seconds to 30
minutes. Refreshing the screen allows you to see the effect of aiming the
antenna to improve signal strength.
Wireless Bridge — Radio
The Wireless Bridge — Radio screen contains wireless bridging
information including the channel number, Tx rate, Tx power, spanning
tree protocol (802.1d) enable/disable, and remote AP's BSSID. This page
is important in setting up your bridge configuration.
29000152-001 B
Chapter 5: Wireless Bridge Configuration
85
Advertisement
Table of Contents
