Bridging And Bridging Encryption; Rogue Ap Detection - 3e Technologies International 3e-525A User Manual

3e-525A Outdoor Access Point
to communicate with the access point. In this case, input the MAC
addresses of all the PC cards that will be authorized to access this
access point. The MAC address is engraved or written on the PC
(PCMCIA) Card.
• If Filtering is enabled and Filter Type is Disallow Access, those
devices with a MAC address which has been entered in the MAC
Address listing will NOT be able to communicate with the access
point. In this case, navigate to the report: Wireless Clients and
copy the MAC address of any Wireless Client that you want to ex-
clude from communication with the access point and input those
MAC Addresses to the MAC Address list.

Bridging and Bridging Encryption

Bridging is covered in chapter five. If you will be deploying this 3e-
525A as a bridge, follow the instructions in chapter five.

Rogue AP Detection

The Rogue AP Detection page allows the network administrator to set
up rogue AP detection. If you enable rogue AP detection, also enter the
MAC Address of each AP in the network that you want the AP being con-
figured to accept as a trusted AP. (You may add up to 20 APs.) Enter an
email address for notification of any rogue or non-trusted APs. (The MAC
Address for the 3e-525A is located on the Setup—General page.
The Rogue AP list, under Monitoring Reports on the navigation
menu, will detail any marauding APs.
28 29000132-001 A