3e Technologies International 3e-527A3 User Manual page 96

Wireless access point – 8 port
Table of Contents

Advertisement

3e–527A3 Wireless Access Point – 8 Port
Wireless Mode
802.11a
802.11a Turbo
Tx Rate
AUTO,
6, 9, 12, 18, 24, 36, 48, 54
Mbps
AUTO
Channel No.
149 (5.745 GHz)
153 (5.765 GHz)
157 (5.785 GHz)
161 (5.805 GHz)
165 (5.825 GHz)
152 (5.76 GHz) Turbo Mode
160 (5.80 GHz) Turbo Mode
Tx Pwr Mode
OFF
FIXED,
AUTO
Fixed Pwr Level
1, 2, 3, 4, 5
Propagation
< 5 Miles
Distance
5-10 Miles
11-15 Miles
16-20 Miles
21-25 Miles
26-30 Miles
> 30 Miles
RTS Threshold
Range 1-2346
BSSID
Enter hexadecimal num-
bers
Note
86
Chapter 5: Wireless Bridge Configuration
Radio Settings
Sets the wireless mode for the wireless bridge.
802.11a
When set to AUTO, the card attempts to select the
optimal rate for the channel. If a fixed rate is used,
the card will only transmit at that rate.
802.11a Turbo
The card attempts to select the optimal rate for the
channel.
802.11a
Sets the channel frequency for the wireless bridge.
802.11a Turbo
Sets the channel frequency for the wireless bridge.
The Tx Pwr Mode defaults to AUTO, giving the
largest range of radio transmission available under
ambient conditions.
The wireless bridge's broadcast range can be
limited by setting the Tx Pwr Mode to Fixed and
choosing from 1-5 for Fixed Pwr Level.
If you want to prevent any radio frequency trans-
mission from the wireless bridge, set the Tx Pwr
Mode to OFF. This will not turn off RF transmis-
sions from any associated wireless devices, but
they will not be able to communicate with the wire-
less bridge when the Tx Pwr Mode is off.
Select a range when Rx Pwr Mode is set to FIXED.
Level 1 is the shortest distance (Level 1=7dBm) and
Level 5 is the longest (Level 5=15dBm)
Set the distance based on the distance between this
bridge and furthest bridge that is connected to it.
The number of bytes used for the RTS/CTS hand-
shake boundary. When a packet size is greater
than the RTS threshold, the RTS/CTS handshaking
is performed.
Add the MAC address of the remote bridge. The
remote bridge's MAC address will appear at the
bottom of the screen.
You can enter a note that defines the location of the
remote bridge.
29000152-001 B

Advertisement

Table of Contents
loading

Table of Contents