Table of Contents
Advertisement
The station transmits when:
1: "ON" is displayed here
Disconnect the palmtop from the station
At the end of the survey, just hold down the receiver push-button
depressed for a few seconds (see page 24) to shut down the station.
* - Station number: choose any number between 1 and 99; specific to the station (it must not
be used by another station operating nearby on the same frequency).
- Frequency: enter the value of the authorized UHF transmission frequency, in MHz.
To start transmitting
2: "Filled up"
then
twice to quit the program
to shut down the palmtop
Write down the beacon
ID & frequency entered
here* (later, you will
have to check that the
rover also uses these 2
parameters)
Minimum transmit rate: 1 s
3: This LED
flashes at
transmit rate
icon
7
Advertisement
Table of Contents
