Subscribe to Our Youtube Channel
Related Manuals for Husky fex21
Summary of Contents for Husky fex21
- Page 1 Getting started with your Husky fex21 Please read these instructions before using your Husky fex21 Contains important safety information...
- Page 2 How to adjust the screen contrast How to use the screen backlight How to use the pen How to enter data How to move the cursor How to reset your fex21 Batteries How to check the batteries Main battery status How to charge the battery...
- Page 3 WPI Husky Technology Limited. Whilst every precaution has been taken in the preparation of this document, the...
-
Page 4: Getting Started
NEVER use solvents of any kind on the case, the keyboard or the display screen. SETTING UP Your fex21 will have left our factory without a battery fitted. To set up a new unit for the first time you should carry out the following steps: 1. Fit the battery pack •... - Page 5 After fitting the battery, press the key at the top centre of the keyboard TWICE to switch your fex21 on - it may take a few seconds before the screen displays data. To switch off, press the key again. If you have not pressed any keys for a few minutes, your fex21 will automatically switch off to conserve power.
- Page 6 Backlight Contrast Power The controls on your fex21 are simple and, for the most part, self-explanatory. The only combination of keys you need to remember is that to reset your computer, as detailed below. How to adjust the screen contrast ù...
-
Page 7: How To Enter Data
To move to the end of the last line, press the keys together. How to reset your fex21 If your fex21 locks up or fails to operate, you may need to reset it in one of two ways. Soft RESET ù... - Page 8 If your fex21 is fitted with an Alkaline battery pack, you can still use the AC adapter to power the unit, but the battery will not be recharged. This is a safety precaution to avoid damage to your fex21.
- Page 9 ‘Main Battery Level’ display. Battery conservation To conserve the batteries in your fex21 you can set it to switch itself off while it is not being used. From the start menu, select Settings, then Control Panel. When the control panel box opens, double-click on the Power icon to open the Power Properties box.
-
Page 10: How To Charge The Battery
Use only the AC adapter and battery charger supplied with your fex21. Connect the AC adapter to an AC mains power supply and plug the charge lead into the power port at the left-hand front of your fex21, pushing it gently until you hear a click. -
Page 11: How To Replace The Battery
Contents How to replace the battery CAUTION: Before removing the old battery pack, check that the fex21 pen is not slotted into the unit. Attempting to remove the battery pack while a pen is fitted may cause damage to both battery pack and pen. - Page 12 Contents Cleaning If the screen of your fex21 should become dirty, clean it with a dry, clean cloth. If the computer gets very dirty, clean it as follows: • Make sure the battery is correctly fitted. If you have dropped your fex21, check that the case is intact.
- Page 13 To use the infrared (IR) communications option, make sure the IR window on your fex21 is pointing at the peripheral’s IR port and is more than 15cm (but no more than 1m) away. If you have difficulties, try again at a different range.
-
Page 14: Ac Power Adapter
Contents AC Power Adapter CAUTION: Use the ac power adapter only after reading and understanding the following instructions. • Hazardous voltages inside. No user serviceable parts inside. Do not attempt to open. • Use indoors only. • Avoid liquid spillage. Do not connect if suspected damp. •... - Page 15 • Do not attempt to open or modify the unit. • Refer to the fex21 label to establish which of the following set of regulatory statements applies: European Modem Only (CTR21) The equipment has been approved in accordance with Council Decision 98/482/EC for pan-European single terminal connection to the public switched telephone network (PSTN).
- Page 16 REN’s, contact the local telephone company. If trouble is experienced with your fex21 modem, for repair or warranty information please contact WPI . If the equipment is causing...
-
Page 17: Electromagnetic Compatibility
2 metres in length. AC adapters employ Husky special provisions to avoid radio interference and should not be altered or substituted. Unapproved modifications or operations beyond or in conflict with these instructions for use may void authorisation by the authorities to operate the equipment. - Page 18 Eden Road, Walsgrave Triangle Business Park Coventry CV2 2TB, England Int Tel: +44 24 7660 4040 Int Fax: +44 24 7660 3060 E-mail: support@husky.co.uk 18167 US 19 North, Suite 285 Clearwater, Florida 33764 USA Int Tel: +1 727 530 4141 Int Fax: +1 727 536 9906 E-mail: techsupport@huskyinc.com...
Need help?
Do you have a question about the fex21 and is the answer not in the manual?
Questions and answers