Table of Contents
Advertisement
Without palmtop:
During data recording, opening inadvertently the flap will only suspend recording. As soon as you close the flap
again, recording will continue automatically, though in another file!! It is therefore worth noting that this event
will inevitably introduce discontinuity in the post-processing of the recorded raw data.
During recording, with the flap properly close, the above LED starting to flash means that the PC Card is full.
22
Depress
Insert a PC Card into the receiver
To start data recording:
1. Press the push-button under the
PC Card slot. The LED below
starts flashing:
2. Close the protection flap. Data
recording starts immediately. The
above LED remains permanently lit
To stop data recording:
1. Open the PC Card flap (the LED
starts flashing again)
2. Press the push-button. The LED
goes out denoting end of recording
to switch on the
receiver
Advertisement
Table of Contents
