Table of Contents
Advertisement
At the station:
- Select
and choose "port B" in line 4:
- Select
the station to use the GSM ("ON" then appears top right).
The station will actually use the GSM only on rover request. The
parameters displayed on this screen (station No., data rate and type)
are normally the right ones as they were chosen earlier to operate
with the U-LINK radio.
At the rover:
- Select
and choose "port B" in line 4:
- Select
mode, select "GSM receiver"
(line 2) and dial the station
GSM call number (line7):
- Press the Q key to read the GSM reception level (it should be "1"
minimum, otherwise the GSM CANNOT be used)
- Press
requested operating mode is available after a few seconds, which
demonstrates that the GSM link operates normally. Go back to the
survey as such.
...
To restore operation with the U-LINK radio, select
mode, press the S key to terminate the communication via GSM, and
then choose "UHF receiver" (line 2).
30
>4 - Connection
>3 - GSM Transmitter and then press
>4 - Connection
>1 - Operating
to call the station. In the status bar, check that the
to allow
>1 - Operating
Advertisement
Table of Contents
