Parameterization - Zennio KLIC-DI Product Manual

4. PARAMETERIZATION

For starting to parameterize the device it is necessary, once the ETS has been
opened, importing the data base of the product KLIC-DI SKY 1.0.vd2.
Then the KLIC is added to the project where it is desired to include the device. Click
with the right mouse button the right button on the device and select "Edit
Parameters.." for starting with the configuration.
In the following sections there is a detailed explanation about each of the different
functionalities of the device in ETS.
4.1. DEFAULT CONFIGURATION
This section shows the default configuration from which the device configuration
starts.
If the window "Edit Parameters" is opened for the first time, the KLIC General
configuration by default will be found.
Next figure shows the General window with the default values:
ZENNiO AVANCE Y TECNOLOGÍA
Figure 4 Default General Configuration
1
www.zennio.com
2