Incline Motor Replacement - Matrix TF30 Service Manual

3.8 INCLI NE MOTO OR REPLA
1) Turn off f power to th e treadmill a
2) Remove e the motor c cover as outl
3) Disconn nect incline m motor wires f
4) Lift or ti lt the treadm mill until there
5) Remove e the bolt fro om the elevat
6) Remove the bolt from m the elevatio
Fig-1
5) Disconne ect the incline e motor from
6) Reverse Steps 1-5 to o install a new
Fig-2
6) Test ful l range of ele evation.
NOTE:
When instal lling a new in ncline motor,
connection points of the e incline moto
CH HAPTER 3 3: Part Re
ACEMENT
and disconne ect the power
lined in Sect tion 3.1.
from MCB an nd ground. C
e is access to o lower conn
tion rack.(Fig g-2)
on with spring g.
m the top mou unting bracke
w incline mot tor.
Fig-3
, make sure t to replace th
or .Replace a any wire ties
eplacemen nt Guide
r cord.
Cut any wire t ties as neede
ecting bolt. ( Fig-1)
et (Fig-3).
he black zinc washers at t
that were re emoved.
ed.
Fig- -4
the top and b bottom
25 5