Table of Contents
Advertisement
10.5 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press
the same time while PYR
flashes in the display.
10.6 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
A
3. Close the door until it is at an angle
of approximately 45°.
45°
4. Hold the door with one hand on each
5. Put the door with the outer side
6. Hold the door trim (B) on the top
and
at
7. Pull the door trim to the front to
8. Hold the door glass panels on their
A
9. Clean the glass panel with water and
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
Make sure that you put the glass panels
(C, B and A) back in the correct
side and pull it away from the
appliance at an upwards angle.
down on a soft cloth on a stable
surface. This is to prevent scratches.
edge of the door at the two sides
and push inwards to release the clip
seal.
2
B
CAUTION!
Rough handling of the glass,
especially around the edges
of the front panel, can cause
the glass to break.
remove it.
top edge one by one and pull them
up out of the guide.
soap. Dry the glass panel carefully.
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
ENGLISH
31
1
Advertisement
Table of Contents
