Changing The Tiller Handle Throttle Grip Rotation - Mercury 10 EFI FourStroke Installation, Operation & Maintenance Manual

2. Install the egress grommet.
a
b
3. Install the starboard driveshaft housing cover. Carefully align the egress
grommet while installing the driveshaft housing cover. Be certain to
tighten all screws to the specified torque.
Description
Driveshaft housing cover screws

Changing the Tiller Handle Throttle Grip Rotation

The engine tiller handle throttle grip rotation can be changed to rotate in the
opposite direction from the factory installation.
1. Remove the starboard driveshaft housing cover. Refer to Driveshaft
Housing Cover Removal and Installation.
2. Install a flag (tape) onto the top throttle cable.
eng
ENGINE INSTALLATION
c
a -
b -
c -
d -
d
63135
Nm
6
121
Throttle cable
Shift cable
Battery cables
14‑pin harness
63136
lb‑in. lb‑ft
53 –