Epa Emissions Regulations - Mercury 10 EFI FourStroke Installation, Operation & Maintenance Manual

Routine cleaning of the remote control external surfaces is recommended to
prevent a buildup of salt and other environmental debris. Use a cloth towel
which has a sufficient amount of fresh water to dissolve and remove salt or
mineral deposits.
When water marks cannot be removed with a damp cloth, mix a 50/50 solution
of warm water and isopropyl alcohol to clean the remote control. Do not use
acetone, mineral spirits, turpentine type solvents, or ammonia based cleaning
products. The use of strong solvents or detergents may damage the coating,
the plastics, or the rubber components on the remote control.
CLEANING CARE FOR TOP AND BOTTOM COWLS
IMPORTANT: Dry wiping (wiping the plastic surface when it is dry) will result in
minor surface scratches. Always wet the surface before cleaning. Do not use
detergents containing hydrochloric acid. Follow the cleaning and waxing
procedure.
Cleaning and Waxing Procedure
1. Before washing, rinse the cowls with clean water to remove dirt and dust
that may scratch the surface.
2. Wash the cowls with clean water and a mild nonabrasive soap. Use a soft
clean cloth when washing.
3. Dry thoroughly with a soft clean cloth.
4. Wax the surface using a nonabrasive automotive polish (polish designed
for clear coat finishes). Remove the applied wax by hand using a clean
soft cloth.
5. To remove minor scratches, use Mercury Marine Cowl Finishing
Compound (92‑859026K 1).

EPA Emissions Regulations

All new outboards manufactured by Mercury Marine are certified to the United
States Environmental Protection Agency, as conforming to the requirements of
the regulations for the control of air pollution from new outboard motors. This
certification is contingent on certain adjustments set to factory standards. For
this reason, the factory procedure for servicing the product must be strictly
followed and, wherever practicable, returned to the original intent of the design.
Maintenance, replacement, or repair of the emission control devices and
systems may be performed by any marine spark ignition (SI) engine
repair establishment or individual.
MAINTENANCE
70
eng