Table of Contents
Advertisement
Parameter
CounterSelector
CounterResetSource
CounterEventSource
CounterReset
TimerSelector
TimerTriggerSource
TimerTriggerActivation
TimerDelay
TimerDuration
5.12
ISPControl
In this property, you can adjust the image sharpness, brightness, saturation, contrast and so on, as shown
in Figure 5-12; please refer to Sheet 5-13 for detailed parameter settings.
Hue and saturation are only available for the color camera.
Explanation
Selects the counter which needs to configure：Counter0 or Counter1.
If Counter0 is selected，CounterEventSource displays FrameTrigger.
If Counter1 is selected，CounterEventSource displays FrameStart.
Selects the signal source to reset the counter：non-reset Off、software signal
reset SoftwareSignal0 and hardware signal reset Line1.
Select the events that will be the source to increment the Counter ：
FrameTrigger/FrameStart.
The selected counter used for software reset.
Selects the counter needs to configure. The default is Timer0.
Selects the trigger source of the start timer. The default is ExposureStart.
Selects the trigger mode of the start timer: RisingEdge, FallingEdge or
AnyEdge.
Sets start timer delay when receiving the trigger.（μs）
Sets the duration of the timing pulse.（μs）
Figure 5-12
ISP Control
43
Advertisement
Table of Contents
