Electrical Connection - Miele PG 8080 Operating Instructions Manual

Electrical connection

Electrical connection

All work on the electrical
connection must be carried out by
the Miele Professional Service
Department, a Miele authorised
technician or a qualified electrician.
– The electrical installation must
comply with the current local and
national safety regulations.
– The connection to the power supply
must comply with local and national
regulations (plug and socket must be
accessible for service and
maintenance work after the machine
has been installed) An electrical
safety test must be carried out after
installation and after any service
work.
– If the dishwasher is hard wired to the
power supply, connection should be
made via a mains switch with all-pole
isolation. The mains switch must
ensure a 3 mm gap between all open
contacts, and must be able to be
locked in the off position.
– For extra safety and protection we
recommend connecting the machine
by a 30 mA residual current device
(RCD).
– Equipotential bonding should be
carried out if required.
– The mains cable may only be
replaced by an original Miele spare
part.
– For technical data see data plate or
wiring diagram supplied.
64
The dishwasher must only be operated
with the voltage, frequency and fuse
rating shown on the data plate.
This machine can be converted to a
different type of power supply in
accordance with the conversion
diagram and wiring diagram supplied.
The data plates (showing relevant text
marks) are located at the back of the
commercial dishwasher and along the
right edge of the open door.
The wiring diagram is supplied with
the dishwasher.
The conversion diagram is attached to
the base panel behind the plastic plinth
cover.