Time Display - Miele PG 8080 Operating Instructions Manual

Time display

Before a programme starts, the duration
of the programme selected appears in
hours and minutes in the display. During
the programme, the time left until the
end of the programme is displayed.
Each programme stage is indicated by
a symbol:
 Pre-wash
 Main wash
 Interim rinse
 Final rinse
 Drying
 Finished
The time displayed may vary with the
same programme. This is influenced by,
amongst other factors, the water
temperature at each intake, the
reactivation cycle of the water softener,
and the amount of dishes.
When a programme is selected for the
first time, the display shows an average
programme duration for warm water.
The programme duration changes if the
electrical connection is changed.
Standby
To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or a few minutes after the end
of the programme. The display and the
indicator lights will go out and only the
Start/Stop indicator will flash slowly.
 Press any button to switch the
display back on.
If the dishwasher is not switched off at
the end of the programme, it will switch
off completely after a few minutes in
Standby mode (see "Settings menu,
Optimise standby").
The dishwasher will not switch into
Standby mode whilst a programme is
running, if salt or rinse aid needs to
be replenished or there is a fault.
You can switch off the reminders to
replenish salt and rinse aid so that
the dishwasher will go into Standby
despite a lack of salt or rinse aid (see
"Settings menu, Refill display").
You cannot switch off fault
messages.
Operation
39