Troubleshooting - Lupine Wilma R Owner's Manual

10

Troubleshooting

Problem Cause
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
With the battery plugged in,
the power LEDs do not come
on, but the PCS LEDs flash.
The Power LEDs do not stay on
for as long as they should.
Even after charging only
the 20% LED will light up
at the Smartcore battery.
The lamp does not recognize
the transmitter.
The transmitter does not light up
while pressing the button and the
lamp does not react.
52 Wilma
Solution
Extremely discharged battery.  Charge the battery. Before
doing so be SURE to read
the "Battery cannot be
charged" section below.
Battery not plugged into the Check all plug contacts.

light or not plugged in
properly.
Faulty LED unit. Replace the LED unit.

Discharged battery.  Charge battery.
Old battery.  Replace battery.
Very low ambient Keep battery warm.

temperature.
Faulty charger. Replace charger.

Unsuitable battery. Use original Lupine battery.

 Discharge the battery with
The indicator was reseted.
your light and fully charge it
afterwards.
Lamphead and transmitter See chapter operation

are not linked. remote control.
See chapter operation

Button cell empty or
remote control.
wrong side up.
Regulations:
The laws governing the allowable application domain for this lighting system may vary from
one country to another. We recommend that you inform yourself about the relevant laws in
this domain in your country.
The mounting technique, as well as the design of Wilma lamps and the Power Control
System (PCS) are protected by European and US patents.
Changes:
Rights for improvements and modifications of our products reserved.
Warranty:
The product's two year warranty applies to all components, as well as any manufacturing defect.
The warranty does not include the battery, however. In addition, any modification or improper
use of the product will void the warranty.
Miscellaneous
Wilma 5 3