Deleting All Settings, Software Reset - RADEMACHER 9485 Instruction Manual For The Electrical Connection And For Commissioning

i

20. Deleting all settings, software reset

A software reset can be carried out to reset the DuoFern Room
Thermostat 9485 to the original default condition as when
supplied.
i
1.
M
+
2.
3.
Start with the settings as specified from page 48 onwards
(installation wizard).
i
120
All settings in menu "9.7 Installer settings" are
also lost in the process.
◆ Make sure that you note all settings in menu 9.7
before carrying out a software reset and check
these after the reset.
OK
+ +
The DuoFern connection data is retained after a
software reset. You can log off or delete DuoFern
devices in menu 9.9.1, see page 103.
Press and hold the four buttons
simultaneously for five seconds until
all of the symbols are shown on the
display.
The software version is then shown
for five seconds.
All settings are deleted and reset to
the default factory settings.
EN