Menu 9.9.3 - Setting The Transmission Channel - RADEMACHER 9485 Instruction Manual For The Electrical Connection And For Commissioning

18.3 Menu 9.9.3 - Setting the transmission channel

If a DuoFern actuator is logged on to the DuoFern Thermostat
9485 via radio, a control valve can be regulated by this. Direct
cabling between the DuoFern Room Thermostat 9485 and the
control valve is not required.
If a multi-channel DuoFern actuator is used for this, the channel
that is used must be set on the DuoFern Room Thermostat 9485.
i
1.
2.
Pay attention when wiring the DuoFern actuator to
the control valve to the channel used and check that
the control valve actually also controls the control
commands of the DuoFern Room Thermostat 9485.
Open menu 9.9.3.
Set and confirm the transmission
channel.
1 = Channel 1
2 = Channel 2
A = All channels
EN
109