Table of Contents
Advertisement
TROUBLESHOOTING, Continued
#16 CONDITION: Ejector does not pick up seals.
CAUSE
1.
Seals improperly seated in cutter block
track.
2.
Dirt in cutter block rear track.
3.
Broken ejector tip.
4.
Screws securing cutter block to
magazine are loose.
5.
Ram roll pin bent.
6.
Broken or bent ejector lever (60) wing
behind jaw stack.
7.
Ejector lever.
REMEDY
1.
Position seals properly.
2.
Brush dirt out of cutter block rear track.
3.
Replace ejector.
4.
Disassemble tool and tighten screws.
5.
Install new roll pin (Page 12, Key 46).
6.
Replace ejector lever.
7.
Lightly tap the seal back into the
magazine. Discard the seal and any
plastic filament lodged in the cutter
block area.
32
Advertisement
Table of Contents
