Table of Contents
Advertisement
#15 CONDITION: Seals do not eject fully and/or cutter blade cuts off seal ends.
CAUSE
1.
Broken ejector spring (Page 12, Key 61).
2.
Severely worn tip on ejector (Page 12,
Key 62).
3.
Severely worn cutter blade (Page 12,
Key 83).
4.
Bent or cracked ejector lever (Page 12,
Key 60).
5.
Screws (Page 12, Key 68) securing
cutter block to magazine are loose.
6.
Seal jam.
REMEDY
1.
Replace ejector spring.
2.
Replace ejector.
3.
Replace cutter blade.
4.
Check by first examining ejector lever
for cracks. If no cracks are found,
connect air to tool and note position of
lugs on ejector in relation to cutter
block. Front of lugs must contact rear
of cutter block. If lugs do not contact
cutter block, ejector lever is bent and
must be replaced.
5.
Disassemble tool, remove screws. Add
one drop of Loctite #242 to each screw.
Reassemble.
6.
Disconnect air source. Pull back ejector
lever and secure in retracted position
by placing an object such as a
screwdriver between the magazine and
the ejector lever. Lightly tap the seal
back into the magazine. Remove the
seal from the magazine and discard
with any plastic beading possibly
lodged in the cutter block area.
31
Advertisement
Table of Contents
