O-Ring - Signode AMPT-12 Operation, Parts And Safe

PARTS LISTS & EXPLODED VIEW
GEAR HOUSING
KEY DESCRIPTION
1 SHCS, 1/4-20 x 3/4
2 Gear Housing Cover
3

O-Ring

4 Needle Bearing
5 Truarc #5008-75
6 Feedwheel Shaft
7 Worm Wheel
8 Wheel Bearing
9 Gear Housing Bushing
10 O-Ring
11 Gear Housing
12 Lock Screw
13 Roll Pin 5/64 x 7/16
or Cotter pin, 1/16 x 5/8
14 Needle Bearing
15 Thrust Bearing
16 Worm Assembly
17 Spacer Ring
18 Idler Gear Assembly
19 Ring Gear
20 Washer
! ! ! !
When ordering parts show tool model, part number and name.
! ! ! !
Common hardware parts may be obtained from local hardware suppliers.
! ! ! !
All recommended spare parts are underlined and should be stocked.
GEAR HOUSING DISASSEMBLY & REASSEMBLY
1. Remove the washer (20) the ring gear (19) and the idler gear assembly (18).
2. Remove the roll pin (13) and loosen the lock screw (12) to permit removal of the spacer ring
(17).
3. Remove the worm assembly (16). Note that the thrust bearing (15) must be reinstalled with the
heavy side of the outer race positioned as shown.
4. Remove the three gear housing cover mounting screws (1), then remove the housing cover (2).
Withdraw the feedwheel shaft (6) and the worm wheel (7). Note that the worm wheel (7) must
be reinstalled with the letter "E" positioned as shown.
5. Parts and housing must be free of metallic particles. Clean as required and regrease using
non-fluid oil K-55. Reassembly gear housing by reversing above instructions. Fill gear housing
to approximately 1/2 full.
6. When reassembled, check gearing for freeness by turning worm assembly (16) clockwise
before attaching air motor.
QTY. PART NO.
3 009041
1 020623
1 008546
1 008549
1 008547
1 006585
1 023561
2 006563
1 006581
1 006594
1 023564
1 008581
1 008582
1 181482
1 008751
1 023754
1 023563
1 008534
3 008815
1 008524
1 008536
20